Deviations
In the upper-left corner of the page, you can find the status of the current tenant.
Deviations are organized into two categories: Deviations which displays the detected configuration deviations in the tenant, and Accepted deviations which displays the configuration deviations that you have previously reviewed and accepted for the tenant.
Under the Deviations tab, you can view the following information and make updates if needed:
- The **Drift detection** chart displays the total number of detected configuration deviations, along with a breakdown categorized by configuration source.
- The **Deviations trend analysis** chart displays the deviations trend over the last 30 days, broken down by configuration source in 5-days intervals.
- In the comparisons section, comparisons are grouped into 4 tabs. You can search for a specific configuration by entering the configuration name in the **Search** text box and press **Enter**. If you want to focus on configurations from a specific baseline, click **Filter**, select the desired baseline, and click **Apply changes**.
Switch among these tabs to review the configurations:
- **Conflicts with baseline** – This tab displays the configurations that are configured differently (same instance name but mismatched property values) in the tenant and the baseline.
- **Unique to baseline** – This tab displays the configurations that are exclusive to the baseline.
- **Unique to tenant** – This tab displays the configurations s that are exclusively to the tenant.
> ***Note**: This tab is visible only when **Drift** **detection** **scope** is set to **All** **supported configurations**, as this option is for comprehensive tenant monitoring which identifies any modifications made to all supported configurations.
- **Matches with baseline** – This tab displays the configurations that are configured identically (same instance name and property values) in the tenant and the baseline.
When viewing the comparisons, you can make updates and deploy the configurations to the tenant when the configurations meet your requirements. For detailed instructions, refer to [Deploy Configurations to a Tenant](#missing-link).
Under the Accepted deviations tab, you can perform the following operations to manage the accepted deviations:
- **Extend duration** – To extend the duration of the acceptance, select the accepted deviation with the **Active** status, and click **Extend duration**. Configure a new duration, enter a comment, and click **Save** to save the changes.
- **Cancel acceptance** – To cancel acceptance, select the accepted deviation with the **Active** status, and click **Cancel acceptance**. Enter a comment and click **Save** to save the changes. The status of the accepted deviation is changed to **Canceled**. Canceling acceptance will re-enable drift detection for the instance or property.
- **Delete record** – To delete a record, select the accepted deviation with the **Canceled** status, and click **Delete**. Click **OK** in the pop-up confirmation message.
In the upper-right corner of the page, you will find the More actions (
) button, which allows you to perform additional actions as below:
*Note: The available buttons vary based on the status of the currently selected tenant.
- **Create** **baseline from tenant** – For detailed instructions, refer to [Create a Baseline](#missing-link).
- **Manage domain mappings** – For detailed instructions, refer to [Manage Domain Mappings](#missing-link).
- **Disconnect tenant** – **Disconnect tenant** – For detailed instructions, refer to [Disconnect a Tenant](#missing-link).
- **Restore to a** **specific** **date** – For detailed instructions, refer to [Restore Tenant Configurations](#missing-link).
- **View** **change** **log** – For detailed instructions, refer to [View Change Logs](#missing-link).
- **Enable**/**Disable** **auto-alignment** – For detailed instructions, refer to [Enable or Disable Auto-Alignment](#missing-link).
- **Manage drift notification** – For detailed instructions, refer to [Manage Drift Notification](#missing-link).
- **Set drift** **detection frequency** – For detailed instructions, refer to [Set Drift Detection Frequency](#missing-link).
- **Discard review process** – For detailed instructions, refer to [Discard Review Process](#missing-link).
